Kemper 131 00 Consignes De Sécurité Importantes Pour Le Montage page 21

Modification of
3
Factory Setting
1. Pull off operating cap (1).
2. Insert screwdriver into
screw slot (2).
3. Now, the temperature,
pre-set at the factory, can
be modified by maximum
half a turn to the right.
10 notch steps correspond
to 2 K. Hereby, stepping is
noticeable.
4. Re-fit operating cap.
5. Check the correct position of
the regulating piston (end
position!) by turning the
operating cap (1) to the left.
© www.kemper-olpe.de – 05.2022 / K410054000001-00 – 21 /88
Note!
After this, the valve has
again to be fully opened
(left turn to end position).
Note!
Do not over-tighten the
end position buffers!