Operation And Use; Installation; Power Connection - SCHOTT EasyLED Plus Conseils D'utilisation

EasyLED Spotlight Plus - Operating Instructions

2. Operation and use

2.1 Installation

A
B
The EasyLED Spotlight Plus System is designed for direct installation on all common microscope
and swivel arm stands. Matching adapters have either been included with the light source or are
available from your dealer (see Point 5 "Accessories").
Start by guiding the matching side of the mounting adapter (A) into the designated holder (5) on the
bottom of the control unit as far as it will go. Proceed by guiding the two fastening screws (M5)
through the groove from the bottom before screwing them in place using an Allen key (3 mm).
You are now ready to clamp the EasyLED Spotlight Plus System onto the microscope or swivel arm
stand using the mounting adapter. You may have to remove the microscope body / carrier
beforehand and refit it when installation is complete.

2.2 Power connection

Plug the barrel connector of the included power supply unit
into the designated mains connection socket (4) on the
control unit.
Please ensure to operate your EasyLED Spotlight Plus
System only with the included power supply unit.
The plug connection of the power supply unit is
interchangeable for EU, UK, US and AU. The plug
connection needs to be connected to the mains supply (100-
240 V AC, 50-60 Hz).
6/10
PI_69