Campbell Hausfeld CL158101AV Mode D'emploi page 6

Operating Instructions
General Troubleshooting Guide
Symptom Possible Cause(s)
Tool runs 1. Grit or gum in
slowly or will tool
not operate
2. No oil in tool
3. Low air pressure
4. Air hose leaks
5. Pressure drops
6. Regulator set too
low
Moisture 1. Water in tank
blowing out
of tool
2. Water in air lines /
hoses
6
Corrective Action
1. Flush tool with Campbell Hausfeld air tool oil, gum
solvent, or an equal mixture of SAE 10 motor oil
and kerosene. If Campbell Hausfeld oil is not used,
lubricate tool after cleaning.
2. Lubricate tool according to lubrication instructions in
the Operation section.
3. Adjust the compressor regulator to tool maximum
while the tool is running free.
4. Tighten and seal hose fittings if leaks are found.
5. Be sure hose is properly sized. Long hoses or tools
using large volumes of air may require a hose with
an I.D. of 1/2 inch or larger depending on total hose
length.
6. Adjust regulator until tool reaches maximum speed.
1. Drain tank (See air compressor manual). Oil tool and
run until no water is evident. Oil tool again and run
1-2 seconds.
2. a. Install a water separator / filter (PA2100 or
PA2110).
NOTE:
Separators work properly only when air
stream is cool. Locate separator / filter as far as
possible from compressor.
2. b. Install a refrigerated air dryer.
2. c. Anytime water enters tool, tool should be oiled
immediately.
www.CH-Commercial.com