Lifetime 60305 Instructions De Montage page 35

Table des Matières

Publicité

SECTION 7 (CONTINUED) /
TOOLS AND HARDWARE REQUIRED /
AIW (x1)
7.8
• One at a time, insert the four tabs at the bottom of a Wall Panel (AHD) or Window Wall Panel (AHH) into the next four
slots along the edge of the Floor. The Window Wall Panel may be inserted on either side of the shed.
• Un par un, insérer les quatre languettes au bord inférieur du panneau mural (AHD) ou panneau mural pour la fenêtre
(AHH) dans les quatre rainures suivantes le long du bord du plancher. Le panneau mural pour la fenêtre s'insère
soit le côté droit soit le côté gauche.
• Uno por uno, insertar las cuatro lengüetas al borde inferior del panel mural (AHD) o panel mural para la
ventana (AHH) en las cuatro ranuras siguientes a lo largo del borde del piso. Se pueden insertar el panel mural
para la ventana en cualquiera de los dos lados.
7.9
• Insert this Corner Wall Panel (AGW) in the same
way as the previous one.
• Insérer le panneau angulaire (AGW) de la même
manière que le panneau angulaire précédent.
• Insertar este panel angular (AGW) de la misma
manera que el panel angular anterior.
AGW
SECTION 7 (SUITE)
/
SECCIÓN 7 (CONTINUACIÓN)
OUTILS ET QUINCAILLERIE REQUIS
ADZ (x35)
AHD
AHH
AHD
AHD
/
INSTRUMENTAL Y HERRAJE REQUERIDOS
7.10
• Insert these Wall Panels (AHD) in the same way as the
previous ones. Do not place Window Wall Panels along the
rear of the the shed.
• Insérer ces panneaux muraux (AHD) de la même
manière que les panneaux précédents. Ne pas insérer
de panneaux muraux pour la fenêtre le long de bord arrière
de l'abri.
• Insertar estos paneles murales (AHD) de la misma
manera que los paneles anteriores. No insertar los
paneles murales para la ventana a lo largo del borde trasero
de la caseta.
AHD
35 35
AHD

Publicité

Table des Matières
loading

Table des Matières