S&P TD-350/100-125 SILENT Manuel D'instructions page 11

adequate thermal
protection has
adjusted to the corresponding limits.
- If a ventilator is installed in a duct, the duct
must be exclusively for the ventilation
system.
Starting up.
Before starting up the machine, make sure
that:
- The apparatus is well secured and the
electrical connections have been carried
out correctly.
- The safety devices have been adequately
connected.
- No loose material or fitting remains can be
sucked up by the ventilator. If the ventilator
has been mounted in a duct, make sure it
is clear of loose material.
- The earth fittings
connected.
- The electrical safety devices are correctly
connected, adequately adjusted and ready
for use.
- The wire and electrical connections inputs
are correctly sealed and water-tight.
When starting up the machine, make sure
that:
- The propeller turns in the correct direction.
- There are no abnormal vibrations.
- If any of the electrical safety devices blow,
the apparatus
disconnected from the mains supply. The
whole installation should be carefully
checked before trying to start up the
machine again.
Maintenance.
- Before manipulating the ventilator, make
sure it is disconnected from the mains
supply even if it has previously been
switched off. Prevent the possibility of
anyone else connecting it while it is being
manipulated.
- The apparatus
inspected. These inspections should be
carried out bearing in mind the machine's
working conditions, in order to avoid dirt or
dust accumulating on the propeller, turbine,
motor or grids. This could be dangerous
and overloading
been connected
are adequately
must be quickly
must be regularly
and perceptibly shorten the working life of
and the ventilator unit.
- While cleaning, great care should be taken
not to unstable the propeller or turbine.
- All maintenance and repair work should be
carried out in strict compliance with each
country's current safety regulations.
Recycling.
- EEC Standards,
responsibility we should assume with
future generations in mind, oblige us to
recycle all the materials we can. Therefore,
please deposit all left-over material and
packaging in their corresponding recycling
containers and hand in the replaced
machines to the nearest handler of this
type of waste product.
If you have any queries about S&P products,
please contact our after-sales service in
Spain, or your local S&P dealer in any other
country. If in doubt, please visit our Web -
Page at www.solerpalau.com
together with the