Start Up Instructions - Garland MONTANA 516 Manuel D'instructions

6. START UP INSTRUCTIONS

6.1. LIST OF MATERIALS
This machine includes the following elements that you
will find inside the box:
• Engine.
• Bar cover
• Bar chain.
• Chain.
• Mounting key.
• Screwdriver
• Instruction manual.
6.2. BAR AND CHAIN INSTALLATION
The chain of the chainsaw has very sharp edges.
Use protective gloves to avoid being cut.
Place the claw.
1. Check the chain brake is not
activated, by pulling
the brake lever backwards
2. Loosen the bolts (1) and
remove the chain guard (2). Once you take off the
cover, VERY IMPORTANT! take off the piece (7).
3. Slip the chain (3) around the sprocket (4) while you
adjust the chain (3) around the bar (5) and
assemble the bar (5) onto the tool. Adjust the
chain tensor, ensuring the pivot of the tensing nut
(6) coincides with the hole on the bar (5).
Pay attention to the correct position of the chain.
The chain must be placed in the direction which is
shown in the figure below:
4. Place the chain guard (2) and tighten the nuts
slightly (1).
5. Tighten the chain. The tension is correct when the
chain can be pulled upwards at the centre of the
bar to its maximum position possible and the tip of
the guiding link does not come away.
43/172
English