Publicité
Les langues disponibles
Les langues disponibles
Installation and connection of the turnout Decoder 61196
The turnout decoder was specially developed for geoLINE electric turnouts for digital operation and is
therefore only suitable for use with digitally operated electric turnouts from geoLINE!
1.
Make sure no power is being supplied to the turnout in which you want to install the turnout decoder.
2.
Connect the 3-pin supply connector (blue/yellow/orange) of the turnout to the turnout drive so that
the colors match (fig. 1).
3.
Now insert the turnout decoder in the electric drive so that the mounting holes in the board are
aligned with the mounting pegs on the turnout (fig. 2). Do this very carefully so that you do not
bend the pins on the turnout decoder connector!
GB
▪ The side of the turnout decoder with the components may be on the top or bottom depending
on the turnout.
▪ There should be one free pin between the supply connector and the turnout decoder (fig. 3).
4.
Carefully mount the turnout decoder using the screws supplied.
Make sure that you do not use too much force when tightening the screw because otherwise you
may strip the threads (fig. 2).
Warning: Take precautions to protect against
hazardous static discharges. If you have ESD
(electrostatic discharge) equipment available,
then use it. Otherwise make sure that you do not
touch the pins on the connector!
Fig. 2
Fig. 3
14
8051250920.indd 14
Fig. 1
The turnout decoder can be:
programmed with switch addresses
▪
controlled digitally.
▪
set using the CV values
▪
Protected against short circuits and overheating
▪
05.02.2018 10:53:31
Publicité
