Publicité
Les langues disponibles
Les langues disponibles
Operation
Electric shock hazard:
Contact with live circuits can result in severe injury or death.
1.
Set the selector according to the Settings Table and connect the test leads to the unit.
Start with the highest measurement range.
Settings Table
To measure
set the selector
this value ...
to this symbol ...
Continuity**
Current (AC)
A
A and press
Current (DC)
∆ ZERO
and press
Diode
the RANGE button
Hz and press
Frequency*
the RANGE button
Resistance
Voltage (AC)
V
Voltage (DC)
V
* Frequency can also be measured with the jaw. Current flow must be at least 5 amps for an
accurate frequency reading.
** Tone indicates circuit resistance is less than 40 Ω.
2.
See Typical Measurements for illustrations of typical uses.
3.
Test the unit on a known functioning circuit or component.
• If the unit does not function as expected on a known functioning circuit, replace the
battery.
• If the unit still does not function as expected, send the unit to Greenlee for repair.
4.
Take the reading from the circuit to be tested.
10
this icon will appear
connect the
on the display ...
red lead to ... black lead to ...
and Ω
+
and A
N/A
and A
N/A
and V
+
Hz
+
Ω
+
and V
+
and V
+
and connect the
COM
N/A
N/A
COM
COM
COM
COM
COM
Publicité
