Sonia Maia Micro Mode D'emploi page 3

COMPONENTS
1
3
1 Diamond-tipped heads
2 Handpieces
3 Flexible suction hose
CONTROL PANEL
1 2 3 4 5
1
Timer
2 Increase time button
3 Decrease time button
4 Power on indicator
5 On / off button
6
Power on indicator
7
Start / Stop button
2
6 7 8 9 10 11
8 Pause indicator
9
Decrease power button
10
Increase power button
11
Power display
REAR PANEL
1
1
Connecting the suction hose
2
Power supply switch
3
Electrical power supply connector
4
Fuse
CONNECTION AND ASSEMBLY
INSTRUCTIONS
● First of all, remove two screws from the bottom of
the main body. A sticker on the device indicates the
need to remove them and highlights the two screws
in question.
● Connect the power cable to the rear panel of the
main body.
● Choose one of the diamond-tipped heads and
connect it to the handpiece using the thread. Put
the cotton filter inside the head first.
● Connect the suction hose to the corresponding
outlet on the rear panel and on the end of the
handpiece, as indicated in the picture. Note the
direction of the arrow on the intermediate filter. It
should be pointing towards the handpiece.
POWER AND CONFIGURATION
● Turn on the power switch on the rear of the
machine and press
The power indicator
will be in standby mode and ready for operation. On
the control panel:
- The timer will show 15 minutes.
- The power indicator will show 5.
- On the
button, the pause indicator
will light up.
● Set the timer using the
2 4 3
on the control panel.
will light up. The machine
or buttons to
EN
3