Tectro TD 1010 Manuel D'utilisation page 51

man_TD1010 ('16).indd 51
NOTE
1. Do not remove the float from the water tank. The water full sensor will no longer
be able to detect the water level correctly without the float and water may leak
from the water tank.
2. If the drainage tank is dirty, wash it with cold or lukewarm water. Do not use
detergent, scouring pads, chemically treated dust cloths, gasoline, benzene,
thinner, or other solvents, as these can scratch and damage the tank and cause
water leakage.
3. When replacing the drainage tank, press the tank firmly into place with both
hands. If the tank is not positioned properly, the "TANK FULL" sensor will be
activated, and the dehumidifier will not operate.
Fig. 7
CONTINUOUS WATER DRAINAGE
The unit features a continuous drainage port. Using a plastic pipe (with an inner diameter
of 10mm) inserts into drain hole (on intermediate plate), reach out from side of water
tank, install it in place, and arrange the drain pipe. The water in the drainage tank can be
continuously drained out from the continuous port on the unit.
MAINTENANCE
CLEANING THE DEHUMIDIFIER
A. TO CLEAN THE BODY
Wipe it with a soft damp cloth.
Fig. 6
Fig. 8
4
51
17-05-16 14:58