Chauvet Professional ROGUE RH1 HYBRID Manuel De Référence page 3

Rogue™ RH1 Hybrid QRG
Replacing The Fuse
Lamp
Replacement
1. Disconnect this product from power.
2. Using a Phillips #2 head screwdriver, unscrew the fuse holder cap from the
housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.
1. Turn the fixture off and disconnect it from power.
2. Wait at least 15 minutes for the lamp to cool down.
3. Loosen 2 Phillips-head ¼-turn screws on rear panel of the head.
4. Take note as to the orientation of the lamp. Vent holes on the front of the lamp
should align horizontally with the air vents on the lamp frame. Orient the
product so that the lamp power wires are coming from the lower right corner
as you are looking at the rear head.
5. Using the lamp base, push the lamp down against the spring clips located on
the bottom, then roll the lamp out the top.
6. Pull the 2 wires connected to the lamp by the spade terminals.
7. Reverse the steps above to install the new lamp.
Please refer to the User Manual for more detailed instructions with images.
RISK OF LAMP EXPLOSION! Vent holes on the front of the lamp should
align horizontally with the air vents on the lamp frame. This is extremely
important for lamp cooling.
Lamp Vent
3
EN
¼-turn
Phillips-head
screws