Power Amp Output; Bridged Mode; Ground-Lift Switch; Mains Input - Electro-Voice CP1200 Mode D'emploi

REAR PANEL
POWER AMP OUTPUT CONNECTORS
To prevent short-circuit and/or to protect your speaker systems from being damaged when connecting
the cabinets, please make sure to mind the Low- and High channels' specifi c pin-assignments!
If, for example, the subwoofer audio signal is used to feed a tweeter, it is more than likely that this will
instantly destroy the HF-driver's coil.
WARNING:
The speaker output terminals are marked with a symbol "
terminals are hazardous live and present a risk of electric shock to the user.

BRIDGED MODE

The regular output voltage of each amplifi er channel A / B is still present at the corresponding output
connector CHANNEL A or CHANNEL B. However, using these signals is not recommendable because
of the aforementioned phase inversion. Operating the power amp in Bridged Mode with loads of 2ohms
connected is not allowable.
CAUTION: Extremely high voltages might be present at the BRIDGED OUT connector during
Bridged-Mode operation. The connected loudspeaker systems have to be capable of handling
such high voltages. Please make sure that power handling specifi cations as stated in the docu-
mentation supplied with your speaker systems match the specifi cations of the power amplifi er.

GROUND-LIFT SWITCH

MAINS INPUT

amp's power output capacity. Make sure to use the supplied mains cord for connecting the power amp
to the mains. Using mains cords with smaller diameters results in higher leakage and consequently re-
duced maximum power output capacity.
At 100V and 120V units the mains fuse is installed internally. This is fore safety reasons. In case of a
blown mains fuse please contact a qualifi ed service personnel for servicing.
Power amp output connection for the two channels A
(left) and B (right) is provided via SPEAKON-type output
connectors.
A plastic cover to prevent inadvertent erroneous
connection protects the BRIDGED OUT connector. Make
sure to remove the cover only when actually operating the
power amplifi er in Bridged-Mode.
CAUTION!
Pins 2+/2- of the CHANNEL A SPEAKON output, which
normally are not in use, are also connected to output B to
ensure comfortable connection of 2-way speaker cabinets
(e.g in Bi-Amping Mode) when using 4-wire Speakon
cables.
With the BRIDGED-MODE switch being engaged, using the channel A input
for audio signal feed is mandatory, since input B provides no function. While
the amplifi er of channel A operates as usual, the audio signal is internally
inverted and routed to the amplifi er of channel B. Both amps – A and B – now
work in push-pull operation to provide doubled output voltage at the
BRIDGED-OUT connector.
The ground-lift switch allows eliminating noise loops. If the power amplifi er is
operated together with other equipment in a 19" rack-shelf, setting the switch
to its GROUNDED position is recommended. If the power amplifi er is operated
together with appliances with differing ground potentials, set the switch to its
UNGROUNDED position.
Under normal circumstances, the mains fuse only blows in case of fault.
Replacing the fuse is only permissible when using a new fuse of the same
type with identical amperage, voltage and blow characteristics. If the mains
fuse blows more often, please contact an authorized service centre.
The high-performance mains cord supplied with your power amplifi er complies
to applicable safety regulations, plus that its diameter corresponds to the power
", which signifi es that these
8