Setup Codes - Maytag Commercial MHN33PD Instructions D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Start Operating Setup
NOTE: Prior to operation, a payment system or an OPL kit must
be installed on PD models as part of the setup.
Before proceeding, it is worth noting that, despite all of the
options available, an owner can simply choose to uncrate a new
commercial washer, hook it up, plug it in, and have a washer
that operates. Washers are preset at the factory for an 11-minute
wash period and three rinses (no extra rinse).

Setup Codes

The Delicates and Knits key pad will advance you from code
to code.
The Brights key pad will change the code value.
The Quick Cycle key pad will select or deselect options.
FOR PN MODELS: The set-up codes are the same as for the
"PD" model except where noted.
The set-up code is indicated by the one or two left-hand
characters. The set-up code value is indicated by the two
or three right-hand characters. The first code shown in each
section is the factory default setting.
CODE
REGULAR CYCLE PRICE (Factory Default)
6 07
6
07
Represents the number of coins (Coin 1) needed
to start the washer; may adjust from 0–39. (See
VALUE OF COIN 1.) Advance from 0–39 by
pressing BRIGHTS key pad. Factory default
of 7 x coin 1.
With coin slide activation, this code represents
the number of push-in actuations of a coin slide
to start the washer.
6 01 setting would represent one coin slide
actuation.
NOTE: For coin slide activation, replacement
of the meter case is necessary.
6
00
PN MODELS ONLY: Factory default of 0 coins.
g
Press the DELICATES AND KNITS key pad once
to advance to next code.
7 11
WASH LENGTH
7 11
This is the number of minutes for Wash. Washer
comes from the factory preset with 11 minutes.
Choose from 9–17 minutes by pressing the
BRIGHTS key pad.
g
Press the DELICATES AND KNITS key pad once
to advance to next code.
NOTE: This option does not apply to Quick Cycle.
8 00
ADDITIONAL RINSE OPTION
This option is either SELECTED 'ON' or NOT
SELECTED 'OFF'.
8
00
Not Selected 'OFF'.
8
Ar
Selected 'ON'. Cannot be combined with the
Super Cycle rinse option.
Press the QUICK CYCLE key pad once for this
selection.
g
Press the DELICATES AND KNITS key pad once
to advance to next code.
9 00
CYCLE COUNTER OPTION
This option is either SELECTED 'ON' or NOT
SELECTED 'OFF'.
EXPLANATION
CODE
9
00
Not Selected 'OFF'.
9
0C
Selected 'ON' and not able to be deselected.
Press the QUICK CYCLE key pad three
consecutive times to select 'ON'. Once selected
'ON' it cannot be deselected.
g
Press the DELICATES AND KNITS key pad once
to advance to next code.
1. 00
MONEY COUNTER OPTION
This option is either SELECTED 'ON' or NOT
SELECTED 'OFF'.
1.
00
Not Selected 'OFF'.
1.
0C
Selected 'ON'.
Press the QUICK CYCLE key pad three
consecutive times to select 'ON' and three
consecutive times to remove (Not Selected 'OFF').
Counter resets by going from 'OFF' to 'ON'.
g
Press the DELICATES AND KNITS key pad once
to advance to next code.
1.
C0
Selected 'ON' and not able to be deselected.
To select 'ON' and not able to be deselected,
first select 'ON', then within two seconds,
press the QUICK CYCLE twice, BRIGHTS once,
and exit the set-up mode.
SPECIAL PRICING OPTIONS
2. 00
This option is either SELECTED 'ON' or NOT
SELECTED 'OFF'.
2.
00
Not Selected 'OFF', and next available code will
be A.00.
2.
SP
Selected 'ON'. Press the QUICK CYCLE key pad
once for this selection.
If SPECIAL PRICING OPTION is selected, there is access
to codes '3.XX' through '9.XX'.
g Press the DELICATES AND KNITS key pad once to
advance to next code.
Options to use if SPECIAL PRICING is selected:
3. 07
SPECIAL CYCLE PRICE
3.
07
Represents the number of coins (coin 1) needed
to start the washer; may adjust from 0–39. (See
VALUE OF COIN 1.) Advance from 0–39 by
pressing the BRIGHTS key pad. Factory default
of 7 x coin 1.
3.
00
PN MODELS ONLY: Factory default of 0 coins.
g
Press the DELICATES AND KNITS key pad once
to advance to next code.
5. 00
TIME-OF-DAY CLOCK, MINUTES
5. 00
This is the Time-of-Day Clock, minute setting;
select 0–59 minutes by pressing the BRIGHTS
key pad.
g
Press the DELICATES AND KNITS key pad once
to advance to next code.
6. 00
TIME-OF-DAY CLOCK, HOURS
NOTE: Uses the 24-hr. clock
6. 00
This is the Time-of-Day Clock, hour setting; select
0–23 hours by pressing the BRIGHTS key pad.
g
Press the DELICATES AND KNITS key pad once
to advance to next code.
EXPLANATION
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mhn33pnMhn33pncgwMhn33prcwwMhn33pdcgwMhn33pdcxwMhn33pdcww

Table des Matières