Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Slide drain hose onto washer connection.
3. Once drain hose is in place, release pliers.
Washer drain system can be installed using a floor drain, wall
standpipe, floor standpipe, or laundry tub.
Laundry tub drain or standpipe drain
Connect the drain hose form to the corrugated drain hose.
To keep drain water from going back into the washer:
Use the drain hose form, and do not force excess drain hose
■
into standpipe. Hose should be secure, but loose enough to
provide a gap for air.
Do not lay excess hose on the bottom of the laundry tub.
■
Floor drain
You may need additional parts. See "Floor drain" under "Tools
and Parts."
Secure the Drain Hose
Drain hose must be secured to stop the hose from moving when
water is pumped out. If the drain hose moves, water may end up
on the floor.
1. Drape the power cord over the washer top.
2. Move the washer to its final location.
10
3. Place the drain hose in the laundry tub or standpipe as shown.
See illustrations A and B.
114 mm
4
/
"
1
2
(114 mm)
(4
")
1
/
2
A
NOTES:
Do not force excess drain hose back into the rear of the
■
washer.
To avoid siphoning, do not seal or put more than
■
114 mm (4½") of the drain hose into drainpipe or standpipe.
Level the Washer
Properly leveling your washer avoids excessive noise and
vibration.
1. Check the levelness of the washer by placing a level on the
top edge of the washer, first side to side, then front to back.
If the washer is against a wall, move the washer out slightly
before tipping it back. If the washer is not level, first prop the
front with a wood block and adjust the feet as necessary.
To adjust feet, use a 14 mm or 9/16" open-end or adjustable
wrench to turn jam nuts clockwise (as viewed from above) on
feet until they are about 13 mm (1/2") from the washer cabinet.
Then turn the leveling foot counterclockwise to lower the
washer or clockwise to raise the washer. Recheck levelness of
washer and that all four feet are firmly in contact with the floor.
Repeat as needed.
2. Make sure all four feet are stable and resting on the floor. Then
check that the washer is perfectly level (use a level).
3. When washer is level and all four feet are firmly in contact
with the floor, use a 14 mm or 9/16" open-end or adjustable
wrench to turn jam nuts counterclockwise (as viewed from
above) on leveling feet tightly against washer cabinet.
IMPORTANT: All four feet must be tightened. If the nuts are
not tight against the washer cabinet, the washer may vibrate.
4
/
"
1
114 mm
2
(114 mm)
(4
")
1
/
2
B
Jam nut
Publicité
Table des Matières
