Philips RQ1200 Serie Mode D'emploi page 15

2 Unfold the charger ('click').
3 Put the adapter in the wall socket.
4 Put the shaver in the charger.
, The display shows that the shaver is charging
(see chapter 'The display').
Charging in the Jet Clean System (specific
types only)
1 Put the small plug in the Jet Clean System.
2 Put the adapter in the wall socket.
3 Hold the shaver upside down above the holder
with the back of the shaver pointing towards
the holder.
Note: The shaver cannot be placed in the Jet Clean
System when the protection cap is on the shaving unit.
4 Place the shaver body in the holder behind the
two clips (1) and press it down until it locks
into place (2).
, The display shows that the shaver is charging
(see section 'Charging' in chapter 'The display').
English
15