Ricoh D2200 Mode D'emploi page 27

• Do not place the machine on an uneven, sloping or unstable surface (such as a trolley) where it
may fall and cause damage to itself or others.
• Do not install the machine in a confined space without proper ventilation and air circulation,
such as in a closed cabinet. Allow proper space around the machine for dissipating heat
inside. Do not block any openings and vents on the machine. Overheating may result in
hazards and electric shock.
• Avoid placing the display in direct sun or where direct sun or spot lighting will shine onto the
LCD panel, as the heat may damage the panel and the external casing of the display, and the
bright light will make viewing the display more difficult than necessary.
• Do not obstruct the machine's air inlet or outlet. Doing so risks fire caused by overheated
internal components or resulting in damage to the product.
• Do not allow foreign objects to enter the machine from the air inlet or outlet.
• If metal objects, or water or other fluids fall inside this machine, you must turn off its power
immediately. After turning off the power, be sure to disconnect the power cord plug from the
wall outlet. Then contact your service representative and report the problem. Do not use the
machine. Doing so could result in fire or electric shock.
• Wire power cables or connection cables so that they will not be caught by a leg or foot. If this
is not done, a person passing nearby may tumble or the machine may fall or tumble over,
resulting in injury or the machine to be damaged.
• Consult your local dealer for wall mount installations. Do not attempt to perform the installation by
yourself. Doing so may result in damaging the wall, causing the product to malfunction, or injury.
The following table lists the environmental specifications for the machine:
Environment
Temperature
Humidity
Maximum altitude
Power
Operating frequency band
Specifications
0 – 32°C (32 – 89.6°F)
10 – 80% (without condensation)
2,500 m (8,202 feet)
AC 100 – 240 V, 50/60 Hz
2402 – 2483 MHz
Environmental Specifications
23