V-TAC 80133970 Instructions D'installation page 9

Step 7: To begin the pairing process, firstly tap and hold the wireless receiver for 5-7 seconds
un�l it starts flashing Green light as shown in the below image.
Once the wireless receiver indicates with flashing Green light, it has been successfully connected
in pairing mode. Tap on "confirm indicator is blinking rapidly" and enter the Wi-Fi username and
password and tap on confirm. (Ensure Wi-Fi Frequency should be 2.4Ghz Only)
Troubleshoo�ng: If the wireless receiver is flashing Red color, please wait for 30 - 60 seconds �ll
the light disappears. Then follow the above process to connect the wireless receiver in pairing
mode.
Note: Before star�ng the pairing process please ensure the wireless receiver is connected to a
device and the power is switched ON.
Step 6: Select the op�on "Electrician"
and select "Breaker (Wi-Fi)" op�on.
4
ENGLISH