Publicité
Les langues disponibles
Les langues disponibles
Unlock Position
Lock Position
If you want to control multiple fans using separate remotes and do not have separate
circuit breakers for each fan, contact customer service at
I C :
11037A-FAN61T4SP-1
This device complies with RSS-210 Issue 8. Operation is subject to the following two conditions:
1.This device may not cause harmful interference, and
2.this device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits pursuant to RSS-210 Issue 8.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and the receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Remote Control
Operate Fan Using Transmitter Code Pre-set by Factory
( Keep Switch Placed In Unlock Position )
Step 1. Restore power to ceiling fan.
Step 2. Install two 1.5-volt AAA batteries provided.
Step 3. Press the "
of the transmitter to operate the fan.
Step 4. Press the "
A dimmer feature is provided on the light .
Press all the way down to get maximum light .
NOTE: The blue light will illuminate to indicate the transmitter is
working.
In Case Of Interference With Other Fans, You Can Change The
Transmitter Code To Operate This Fan Only.
Step 1. Shut off power to all fans at wall switch. At the circuit breaker,
reset the power (turn OFF and back ON) for the fan you are
re-programming.
Step 2. Within 30 seconds of resetting the power, turn wall switch back
on, switch the lock
"lock "
position. Push the Sync "
until the light on the fan flashes 3 times.
Step 3.Repeat steps for each fan that needs re-programming.
" button located on the front
" button to operate the light .
/unlock
button on the back of the transmitter to
" button for about 5-10 seconds,
1-866-885-4649
1 2 3 4
.
13
Publicité
