GE 21823 Manuel De L'utilisateur page 10

MOUNT FAN BODY
1
Loosen two (one of each across) of the four screws
(U) from the mounting bracket (N) and remove the
other two.
Remove the motor assembly (O) from the hook of
2
mounting bracket (N) and push up the motor
assembly (O) until the two screws on mounting
bracket (N) are engaged with L type slot holes on
canopy of the motor assembly (O).
Rotate the motor assembly (O) slightly until the
3
two screw heads are in the L type slot holes.
4 Install the two screws previously removed and
tighten all four screws.
Push the canopy trim ring up until it
5
locks into place at the top of on the
canopy.
ATTACH FAN BLADES
Assemble fan blade bracket (S) to
1
fan blades (T).
F
S
10
Fan Installation
2 Remove the corrugated paper
motor blocks.
T
U
Canopy
Trim Ring
NOTE: Do not test fan until
fully assembled. Fan will not
operate without light kit
attached.
WARNING: After making the
electrical connections,
carefully unhook the fan
and hold the fan firmly while
attaching the fan to the
mounting plate.
3
Attach blades to motor assembly.
N
O
G