CYBEX gold PALLAS G I-SIZE Mode D'emploi page 10

If required the belt of the Top Tether can be extended by pressing the Top
��
Tether Adjustment Button.
EN
11. Tighten the Top Tether Belt (s) until the Top Tether Safety Indicator (x)
turns green.
Pass the Top Tether Belt underneath the car headrest. Never pass the Top
��
Tether Belt over the car headrest.
12. The seat can be brought into a sitting or lying position by pressing the
position adjustment button (w) and moving the seat forward or push back.
REMOVING THE CAR SEAT FROM THE VEHICLE
Perform the installation steps in the reverse order.
1. Loosen the Top Tether Belt (s).
2. Unlock the ISOFIX Locking Arms (n) on both sides by pushing the ISOFIX
Release Buttons (p) and pulling them back simultaneously.
3. Pull the seat away from the ISOFIX Anchorage Points (o).
4. Remove the car seat and push the ISOFIX Locking Arms (n) fully back into
the transport position.
5. Attach the Top Tether Belt (s) to the parking position (t).
ADJUSTING THE HEADREST
The Adjustable Headrest (b) can be adjusted by using the Headrest Height
Adjuster (d) at the back of the headrest (b). Adjust the headrest so that max.
2 cm (approx. 2 finger's width) remain between the child's shoulder and the
headrest.
The height of the headrest can still be adjusted while the seat is installed in
��
the car.CORRECT INSTALLATION MODE
8
CORRECT INSTALLATION MODE
76 cm – 105 cm,
max. 21 kg
Installation mode with impact shield
Installation
SECURING THE CHILD WITH IMPACT SHIELD: 76 CM – 105 CM
(MAX. 21 KG)
1. Loosen the Belt of the Impact Shield (l) by pressing the Belt Adjuster
Release Button (j) on the Belt Adjuster (k).
2. Open the buckle of the Impact Shield (h) on the Impact Shield (g) and lay
the impact shield on its side.
3. Now place your child in the seat.
��
Make sure that the headrest is adjusted correctly.
4. Put the Impact Shield (g) back and insert the Tongue of the Impact Shield
(i) into the Buckle of the Impact Shield (h) so that it engages with an audible
"CLICK".
5. Now pull on the Belt (l) of the Impact Shield to adjust it and restrain your
child correctly. Move the impact shield a little to the left and right to achieve
an optimal fit and position
6. The impact shield (g) must be adjusted so that it fits snugly against the
child's body and pelvis.
The tightening of the adjustment belt must be repeated each time you
��
buckle up.
7. Check whether the lock tongues (i) are properly engaged by pulling on the
Impact Shield (g).
100 cm – 150 cm
without impact shield