Ducting Mode; Filtering Mode - THOMSON DTT61XD Guide D'installation Et D'utilisation

2 / INSTALLING YOUR APPLIANCE

Ducting mode

•
Connect the flange of the hood with the air venting
hole made previously in the wall/ceiling by means
of an adequate tube.
Make the electrical connections.
Warning
This is the filtering version of your
cooker hood; you must first remove the
charcoal filters.
Tip
For optimal use of your appliance, we
recommend that you connect the hood to a
150 mm-diameter flue (not delivered with the
appliance). Minimise the number of angles
and bends and the lengths of the flue. In
the event that the hood will be operated
using out-door evacuation, you should
ensure a sufficient inflow of fresh air to
avoid a pressure deficiency in the room.
Non-return valve
In the case of installation with air evacuation
to the outside, fitting the non-return valve
prevents the wind from entering and the air
from returning.
Caution: Before fastening the air exhaust
pipe to the motor, check that the non-return
valve on the air vent can move freely.

Filtering mode

•
Connect an adequate pipe to the connecting
flange of the appliance so that it conveys the air up
to the top of the pensile cupboard (pipe is not
provided).
Make the electrical connections.
All manuals and user guides at all-guides.com
24
EN