Connecting The Power Supply - AEG MTD 350 Manuel D'utilisation Et Installation

Installation - for contractors
» Route the power cable through the cable entry in the
back panel.
» Hook in the appliance cover with the heater at the
bottom.
» Click the heater into place using the snap fastener.
» Secure the appliance cover with the cover fixing
screws.
10.2.2 Tap installation
Material losses
!
When making the connections, counter the torque
on the appliance using a size 14 spanner.
Pressurised connection
» Fit the 3/8 connection hose provided and the 3/8 tee.
» Install the tap. For this, also observe the tap operat-
ing and installation instructions.
Non-pressurised connection
» Install the tap. For this, also observe the tap operat-
ing and installation instructions.
32

10.3 Connecting the power supply

DANGER Electrocution
Carry out all electrical connection and installation
work in accordance with regulations.
DANGER Electrocution
Ensure that the appliance is earthed.
Ensure the appliance can be separated from the
power supply by an isolator that disconnects all
poles with at least 3 mm contact separation.
DANGER Electrocution
The appliances are delivered with a power cable
MTD 350
( with plug).
Connection to a permanent power supply is pos-
sible, provided the fixed cable has a cross-section
that is at least equal to that of the standard power
cable of the appliance. A maximum cross-section of
3 x 6 mm² may be used.
Material losses
!
When making the connection to a standard safety
socket (in the case of a power cable with plug), en-
sure that the socket is freely accessible after the
appliance has been installed.
Material losses
!
Take note of the type plate. The specified voltage
must match the mains voltage.
» Connect the power cable as shown in the wiring dia-
gram (see chapter "Specification / Wiring diagram").