Operation; General Information; Structure Of Safety Instructions - AEG MTD 350 Manuel D'utilisation Et Installation

- The specified voltage must match the mains
voltage.
- In the case of damage, the power cable
must only be replaced by a qualified con-
tractor authorised by the manufacturer
using the original spare part.
- Secure the appliance as described in chap-
ter „Installation / Installation".
- Observe the maximum permissible pres-
sure (see chapter „Specification / Data
table").
- The specific water resistivity of the mains
water supply must not be undershot (see
chapter "Installation / Specification / Data
table").
- Drain the appliance as described in chapter
„Installation / Maintenance / Draining the
appliance".
Operation - for users and contractors

OPERATION

1. General information

The chapter "Operation" is intended for appliance users
and qualified contractors.
The chapter "Installation" is intended for qualified con-
tractors.
Note
Read these instructions carefully before using the
appliance and retain them for future reference.
Pass on the instructions to a new user if required.
1.1 Safety instructions

1.1.1 Structure of safety instructions

KEYWORD Type of risk
Here, possible consequences are listed that may
result from failure to observe the safety instruc-
tions.
» Steps to prevent the risk are listed.
25