B.A. International Optima OS600L Mode D'emploi page 13

5.8 Change in torque value
Change the torque value of motor, 5 N.cm increase.
Torque Up/Down
Button
5.9 Change in speed
SPEED Up/Down
Button
5.10 Operation of implant engine
Implant engine operates upon completion of all settings.
When motor operates by pressing foot switch, the letter 'R' on display and the surrounding border flickers in turn.
5.11 Auto Calibration
SPEED Up/Down
Auto Calibration is performed upon simultaneously pressing both buttons longer than 2 seconds.
Button
Auto calibration is recommended after sterilization.
Torque section on the display flashes upon pressing torque button.
Torque is controlled using the button for adjusting set value.
Torque setting mode is exited by pressing Torque button again or another button for another function or when the motor is operated.
Gear ratio
1:1
16:1
27:1
Speed section on the display flashes upon pressing Speed button.
Speed is controlled using the button for adjusting set value.
Speed setting mode is exited by pressing Speed button again or another button for another function or when the motor is operated.
Gear ratio
1:1
16:1
27:1
The torque and speed indicate the current figures and a beep sounds when altered torque value reach 90% of set value.
Motor stops when it reach 100% of set value.
When users press the speed up and down button simultaneously for 2 seconds, auto calibration is executed.
When auto calibration is executed, the motor starts with a beep sound.
Auto calibration is completed when speed increases from 0 to 40,000 RPM on the display and the motor will stop when it's done.
Auto calibration is recommended when actual speed of the motor is different from speed on the display.
12
Torque(Ncm) Gear ratio Torque(Ncm)
- 1:2 -
5~60 20:1 5~70
5~80 32:1 5~80
Speed(rpm) Gear ratio Speed(rpm)
200~40,000 1:2 400~80,000
12~2,500 20:1 10~2,000
7~1481 32:1 6~1250