Setup; Step 1: Connect Your Monitor To Your Computer; Connecting To A Second Computer - Sony Trinitron CPD-G400 Mode D'emploi

Setup

Before using your monitor, check that the following accessories
are included in your carton:
• Power cord
• G3 adapter (for Macintosh blue and white system)
• Windows Monitor Information Disk
• Warranty card
• Notes on cleaning the screen's surface
• This instruction manual
Step 1: Connect your monitor to
your computer
Turn off the monitor and computer before connecting.
Notes
• Do not touch the pins of the video signal cable connector as this might
bend the pins.
• When connecting the video signal cable, check the alignment of the
HD15 connector. Do not force the connector in the wrong way or the
pins might bend.
x Connecting to an IBM PC/AT or compatible
computer
AC IN
to video output
IBM PC/AT or
compatible computer
6
(HD15) (HD15)
1 2
x Connecting to a Macintosh or compatible
computer
Use the supplied G3 adapter (for blue and white system).
AC IN
G3 adapter (for blue and white
system) (supplied)*
to video output
Power Macintosh G3
* Connect the supplied Macintosh adapter to the computer before
connecting the cable. This adapter is compatible with the Power
Macintosh G3 computer that has three rows of pins. If you are
connecting to the other version of Macintosh G3 series computer with
two rows of pins or other models, you will need a different adapter (not
supplied).
x Connecting to a second computer
AC IN
to video input 2
connector (y 2)
Refer to the preceding examples
to connect your computer.
(HD15) (HD15)
1 2
(HD15) (HD15)
1 2
HD15 video signal
cable (not supplied)