AUTO-HAK R25A Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
7
B
5
A
14
C
9
10
12
8
This towbar is designed to assembly in following cars:
FIAT PUNTO II, 3/5 doors VAN (188), except Sport, produced since
09.1999 till 2011, catalogue no. R25A and is prepared to tow trailers max
total weight 1400 kg and max vertical mass 75 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
6
A
14
10
C
1
3
From manufacturer
1. Disassemble the rear bumper.
2. Lower the silencer and unscrew the thermal sheet.
3. Take plastic covers out the bottom part of chassis members.
4. Under the conservation layer in the luggage part (please look for it in
the nearest part of rear car`s side), find elongated holes at the left and
12
right side. Slide special elements with nuts (pos. 6 and 7) there.
5. Apply left bracket (pos. 5) to the left chassis member, and right
9
bracket (pos. 4) to the right one, then fit these elements to slided
8
earlier nuts (pos. 6 and 7) through holes A, and next fit them to the
rear panel through holes B.
6. Drill holes of supports C (use bit ø12,5mm).
4
7. Fix the main bar of the towbar (pos. 1) to brackets (pos. 4 and 5) with
B
bolts M12x35mm (pos. 8.)
8. Fix body of the automat and place tow-ball according to supplied
instruction. Note! Remember to place socket plate (pos. 3) as shown
on the drawing 1.
9. Replace the silencer, the thermal sheet and the bumper.
2
10. Tighten all bolts according to the torque shown in the table.
11. Connect electric wires of 7-poles socket according to the instruction
of the car. (Recommend to make at authorized service station).
12. Complete paint layer damaged during installation.
M6 - 11 Nm
M12 - 87 Nm
After install the towbar you should get adequate note in registration book
(at authorised service station). The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar
must be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm
M14 - 138 Nm
NOTE
M10 - 50 Nm
M16 - 210 Nm