Hardware Model Overview; Front View; 1000Base-X (Sfp) Ports; 10/100/1000Base-T Gigabit Ethernet Ports - Dell PowerConnect W-650 Mode D'emploi

Hardware Model Overview

Front View

Figure 1

1000Base-X (SFP) Ports

There are two 1000Base-X ports for fiber connectivity only and are intended for use with Dell W-Series SFPs
(mini-GBICs).
To purchase compatible SFP modules, contact your Dell sales representative for details and assistance.
Note: Dell tests and supports Dell optics within their controller system. Third party optics are not tested or supported; therefore,
Dell does not guarantee proper functionality of third party optics when used in a Dell system.

10/100/1000Base-T Gigabit Ethernet Ports

There are six 10/100/1000Base-T Gigabit Ethernet (RJ-45) ports on the W-650 Series. Gigabit Ethernet uses all
eight wires and each pair is used in a bi-directional fashion, meaning the same pairs are used for both data
transmission and reception. Figure 2 illustrates the CAT-5 pin-out found on an RJ-45 connector. The CAT-5 pin-
out pairs the following pins on a 10/100/1000Base-T Gigabit Ethernet port: 1/2, 3/6, 4/5, and 7/8.
Figure 2

Serial Console Port

A serial console port is provided for connection to a terminal, allowing for direct local management.
8 | About the W-650 Series Controller
W-650 Series Front View
WLAN LED
10/100/1000Base-T Gigabit
Ethernet Ports with PoE
Gigabit Ethernet Port Pin-Out
10/100/1000Base-T
Gigabit Ethernet Ports
USB ports
1000Base-X (SFP) Ports
Signal Name
RJ-45 Female
Pin-Out
BI_DA+
1
BI_DA-
2
BI_DB+
3
BI_DC+
4
BI_DC-
5
BI_DB-
6
BI_DD+
7
BI_DD-
8
Dell PowerConnect W-650 Controller | Installation Guide
Serial Console Port
Media Eject Button
Function
Bi-directional pair +A
Bi-directional pair -A
Bi-directional pair +B
Bi-directional pair +C
Bi-directional pair -C
Bi-directional pair -B
Bi-directional pair +D
Bi-directional pair -D