Grundig M 2000 BT Mode D'emploi page 25

CONNECTION­AND­PREPARATION
Connecting­the­loudspeakers
1
Insert the wires of the loudspeaker cable into
the »SPEAKER­OUTPUT­(4­�)­R­­L« fasteners
on the hi-fi system.
Notes:
Observe the left and right channels (L = left
7
channel, R = right channel).
Connect each of the red sockets (+) on the
7
hi-fi to the red sockets (+) on the loudspeak-
ers.
Connecting­the­antenna
1­Plug the roof antenna cable into the antenna
socket »FM­ANTENNA« on the hi-fi system.
Note:
If no roof antenna is available, use the
7
auxiliary antenna supplied. When suitably
positioned and with adequate signal, this
antenna provides adequate reception of
FM channels. Do not shorten the auxiliary
antenna.
Connecting­ an­ MP3­ player­ or­ a­
USB­memory­stick
Caution:
The hi-fi system must be switched off while
7
the USB connection is being made. If it is not
switched off, data can be lost.
1
Connect the USB interface of the MP3 player
to the » « socket of the hi-fi system with a
standard USB cable;
or
insert the USB plug of the USB memory stick
into the USB interface »
tem.
Connecting­external­devices
1
Connecting­the­headphones
1
« of the hi-fi sys-
Note:
Switch the hi-fi system off before you connect
7
external devices.
Use standard audio cables to connect the
audio outputs of the external device to the
»AUX­IN« sockets on the hi-fi system.
Insert the headphone plug (3.5 mm) into the
» U « socket on the hi-fi system.
Note:
The loudspeakers of the hi-fi system are
7
switched off.
Caution:
Excessive volume levels when using head-
7
phones or earphones can damage your
hearing.
­---------------------------------------
25­
ENGLISH