Publicité
Les langues disponibles
Les langues disponibles
7.
Draw end of joint marked with L to left standing lights:
a)
Disconnect 5-input joint of vehicle from left standing lights, disassemble end on grey/white cable (fog
lights) from well no. 4 with a suitable tool. Connect 5-input joint to standing lights (well no. 4 will remain
empty),
b)
Fasten end on grey/white cable in the supplied 1-input casing and then connect it to a suitable joint of
electric bunch (grey cable),
c)
Connect 2- and 3-input joints of electric bunch to sockets present in left standing lights,
8.
Fitting turn indicator relay and additional control light:
a)
Remove the legroom cover under the dashboard on the driver's side.
b)
Remove the existing turn indicator relay and insert the supplied relay into its socket.
Note: A clicking sound will be heard when the turn indicator is activated.
c)
For the additional control light, drill a Ø 10 mm hole at a suitable place in the driver's field of view (e.g. an
unused switch faceplate). Lead the supplied cable for the control light from the relay to the backside of the
newly drilled hole. Push the two plug-in sleeves onto the control light and insert this into the mounting-hole.
Connect the 2-pin connector housing to the corresponding vacant connector slot of the relay.
Secure the cable set with supplied cable ties, re-install all trims and other parts which were removed during
installation.
Connect the earth lead to the battery and check all vehicle functions with connected trailer or suitable testing device
If the trailer is connected, the indicator lamp blinks when direction indicators (3 x 21W) or warning lights (6 x 21W)
are on.
Publicité
