Publicité
Les langues disponibles
Les langues disponibles
42 02 07R / 11.06.2019
Packing list:
1 8-conductor cable set
1 Socket 7-pin
1 Socket retaining plate
1.
Disconnect the earth lead from the battery
2.
Remove inside screens of boot near tail lights of vehicle.
3.
In order to draw electric bunch to connection socket, drill a hole of 6 mm diameter in boot floor (possible opposite to
socket mounting point). Increase the diameter to 20mm. Secure edge with anti-corrosion agent.
4.
Connect the cable set in the following way:
a)
Bring the 8 wire end of the wiring set with a sleeve terminal through the bushing (made at item 3) from the
boot space outwards and further on, through the hole on the socket clamp.
b)
Draw attached rubber socket retaining plate over the end of cable set (if necessary use anti-friction agent),
c)
Disassemble the socket and connect cables according to the following assignment:
Picture1
Function:
Indicator left
Fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
Fog light
5.
Assemble connection socket with packing washer using enclosed screws and nuts on socket holder,
a)
Carefully fasten washer in the appropriate way,
b)
Fasten electric bunch in such a way that there are no sharp bends and no wear.
Draw end of joint marked with R to right standing lights. Connect 2- and 3-input joints to sockets present near
6.
standing lights.
Electrical Set for Trailer Connection
7-pin
VW Polo Steilheck manufactured 09.94 - 09.99
VW Polo Stufenheck manufactured 12.95 - 09.99
Part no.:
WYR
1 Relay with C2 output
1 Green control light
1 Cable for control light
Installation instruction
Contact description:
1
(L)
2
(54-G)
3
(31)
4
(R)
5
(58-R)
6
(54)
7
(58-L)
8
(58-b)
420207R
1 Rubber grommet
3 Screws M5X35
3 Nuts M5
Cable colour:
black/white
grey
brown
black/green
grey/red
black/red
grey/black
grey/white
3 Spring washer
8 Cable ties
1 Rubber grommet
1
2
6
7
3
5
4
8
Contact description in
7-pin socket
Publicité
