KSR KUEBLER BNA Mode D'emploi page 12

3. Installation and commissioning
Attachment example (magnetic switch to magnetic roller display)
GB
Loosen the mounting screws (1) on the magnetic switch by about
■
one turn using an Allen key size 3 mm
Push the sliding block(s) (2) into the guide groove (3) of the magnetic
■
roller display (4) from the top or the bottom. (Please note the position
of the cable connection or the plug as shown in the illustration)
Push the magnetic switch to the height of the required switching
■
point and fix in place by tightening the screws (the switch point is
marked on the product label).
12
The magnetic switch is attached to the magnetic roller level
display (4) of the bypass level indicator (6) by means of
sliding blocks (fig. 3).
The magnetic switch MA has been designed for attachment
on the right-hand side of the magnetic roller display (4). If
it is mounted on the left-hand side, the switching function
is reversed. The switch has to be mounted the other way
round (product label is upside down).
KSR KUEBLER Operating Instructions Bypass Level Indicator – BNA