KSR KUEBLER BNA Mode D'emploi page 11

3. Installation and commissioning
Fig. 2: Sensor to the bypass tube
1 Sensor MG ...
2 Tightening strap
3 Magnetic roller display
4 Cheese-head screw or
comparable
5 Mounting clamp
6 Mounting lug
Use the tightening strap or mounting
clamp (pos. 5) to attach the sensor
MG ... to the bypass tube.
The distance between the position
sensor (magnetic system in the
float) and the sensor tube should
not exceed 8 mm depending on the
magnetic system.
The bypass tube must never be
scored or drilled into or welded
directly.
KSR KUEBLER Operating Instructions Bypass Level Indicator – BNA
GB
11