Publicité
Les langues disponibles
Les langues disponibles
Care And Maintenance
CLEANING INFORMATION:
• Make sure the unit is turned off, unplugged and the heating elements of heater are cool whenever you are cleaning the
heater.
• Clean the metal trim using a water-dampened, soft, and clean cloth. DO NOT use brass polish or household cleaners as
these products will damage the metal trim.
• The motors used on the fan and the flame generator assembly are pre-lubricated for extended bearing life and
require no further lubrication. However, periodic cleaning/vacuuming of the fan/heater and air intake/output vents is
recommended.
• Any other servicing should be performed by an authorized service representative.
• Allow at least 10 minutes between turning off the unit and removing the light bulb to avoid accidental burning of the skin.
WARNING: Make sure the power is turned off before proceeding. Any electrical repairs or rewiring of this unit
should be carried out by a licensed electrician in accordance with national and local codes.
If repairing or replacing an electrical component or wiring, the original wire routing, color coding and securing
locations must be followed.
WARNING: Electrical outlet wiring must comply with local building codes and other applicable regulations to
reduce the risk of fire, electrical shock and injury to persons.
WARNING: Do not use this fireplace if any part of it has been under water. Immediately call a qualified service
technician to inspect the fireplace and replace any part of the electrical system.
WARNING: Disconnect the power before attempting any maintenance or cleaning to reduce the risk of fire,
electrical shock or personal injury.
WARNING: During any service of this appliance, the power to the unit must be turned off. First turn the main
power switch to the "OFF" position. Then remove the electrical plug from the wall outlet.
NOTE: When the heater is not in use, it should be stored in a dry location, away from possible damage. The
power cord should be stored properly to avoid contact with hot or sharp objects.
CHANGING THE LIGHT BULB
• The fire effect is created with the use of a 40-Watt B-10 candelabra light bulb with an E-12 (small) socket base. The light
bulb will have to be replaced from time to time when they burn out.
• During normal operation, the stove heater will always give a simulated flame function. If the intensity of flame suddenly
increases, it means that the light bulb is going to burn out. Replace the light bulb immediately, according to the instructions.
Do not operate the stove heater when the light bulb burns out or without the light bulb.
STEP 1: Turn the main power switch off, and then unplug the power cord
from the wall outlet.
STEP 2: Loosen the screws holding the stove back panel to the main body
of stove.
STEP 3: You will find a 40-Watt B-10 candelabra light bulb with E-12 socket
base at the bottom.
STEP 4: Replace the burned out light bulb using a new 40-Watt B-10
candelabra light bulb.
STEP 5: Reinstall the back cover.
STEP 6: Plug in the unit.
8
Publicité
