Operation - Textron Greenlee UT2 Manuel D'instructions

Operation

After fishing the pull rope through the conduit, wind it
around the capstan. The puller will pull at two different
speeds depending on whether the rope is on the large or
small diameter. To pull at the slower speed, place the
rope at the inner most part of the smaller capstan
diameter and wind the rope clockwise and outward.
To pull faster, do the same on the large diameter section
of the capstan.
Low Speed
Hi Speed
Greenlee / A Textron Company
UT2 Cable Pulling System
When ready to start pulling cable, use only a few wraps
of rope on the capstan at first. Using too many wraps will
reduce your ability to control the rope on the capstan.
Use the right angle sheave to position yourself so you
are not in line with the high-tension rope in case it, the
cable or the connector breaks.
Turn on the puller and gradually apply a tailing force to
the free end of the rope. If the tailing force becomes
uncomfortably high, turn off the puller and add another
wrap. If the rope starts climbing up the inside ramp of the
capstan, ease up in the tailing force to allow it to settle
down to the base diameter. If it is continually climbing up
the ramp, turn off the puller and remove a wrap.
10
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070