Publicité
Les langues disponibles
Les langues disponibles
EN
II. GENERAL INFORMATION & FEATURES
This is used to turn the unit on or off.
There is one LED indicator for the power
NOTE : IF A FAULT OCCURS WITHIN A PARTICULAR ZONE, THE LED
CHANGES TO RED. IF THE FAULT REMAINS, THE CORRESPONDING LED
REMAINS RED AND YOU MUST POWER CYCLE OFF AND ON TO CLEAR
THE FAULT. IF THE FAULT IS MOMENTARY, THEN THE ZONE LED CHANGES
TO RED AND THEN SWITCHES TO SOLID WHITE AFTER A FEW SECONDS.
ONCE ALL ZONES ARE CLEARED OF FAULTS THE FRONT LED'S WILL TURN
WHITE AS LONG AS THEY ARE ACTIVE.
FRONT PANEL
POWER SWITCH
LED INDICATORS
and each zone.
16
REAR PANEL
On/Auto/Trigger Switch :
ON MODE
The corresponding zone always at "ON" mode, the amplifier will work when
the zone receiving audio signal.
If the zone detecting no problem, the LED lights will be white; if the zone
detecting some problems, the LED lights will be red.
AUTO MODE
The inputs on the amplifier will detect an audio source and turn on when a
source is present; after approximately 15 minutes without an audio source
the amplifier will go into standby mode. After entering sleep mode there
will be a 2-3 second power cycle period from sleep mode to play an audio
signal. All zones at « AUTO » then the amplifier can be in standby if no signal
15 minutes.
TRIGGER MODE
The amplifier will only turn on and off when using the 12v input and/or output.
There will be a 2-3 second power cycle period from time power is applied to
the trigger to play an audio signal. For general use it is recommended the
amplifier be left in the "AUTO" position.
17
Publicité
