Publicité
Les langues disponibles
Les langues disponibles
EN
III. CONNECTING THE AMPLIFIER
Always turn off the power of your amplifier, processor/preamp and all
output/playback units before any connections are made. Before turning
your amplifier and preamp back on, make sure your source volume is turned
all the way down.
Remember the cooling issues mentioned earlier in this manual. Improper
airflow will reduce the life of the amplifier. When deciding on the final
location, keep in mind that there needs to be adequate space behind the
amp to fit the speaker cables and patch cables.
STEREO CONNECTION
Use a good quality RCA type audio cable. Connect a stereo RCA cable from
your audio source to one of the inputs (Bus A & B or line-in) on the back of the
amplifier. Repeat this for each channel and/or zone if using the line-in inputs.
The Bridge/Normal switch should be in the normal stereo mode.
Connect the speaker cable coming from each pair of speakers to the
"Speaker Output" connector on the back of the amplifier. This connector
is removable to make connection easier. When connecting the cable to
the connector, check for any wire strands that might be sticking out of the
connection terminalthat might cause a short circuit. These amplifiers are
stable down to 4 ohms. The impedance with the connected speakers should
not be lower than 4 ohms.
BRIDGED CONNECTION
The bridging mode is meant for a single speaker and high power application
such as Home Theater. In the bridged mode the speakers should be 8 ohm
minimum. Make sure the amplifier power is OFF before making connections.
Connect the right and left outputs from the audio source to the left input of
the zone you are bridging. Repeat this for each zone you want in bridged
mode. The bridge/normal switch should be in the bridged (BR) position. Make
sure the switch is in this mode only on the zones you want bridged.
Connect the speaker cables coming from one speaker to the "speaker
output''connector on the back of the amplifier. For bridging, one speaker
will connect to one connector. Make sure to follow the labeling on the back
of the amp where the speaker output connector is for the bridged zone. The
speaker output connector is removable to make connection easier. When
connecting the cable to the connector, check for any wire strands that might
be sticking out the connection terminal that might cause a short circuit.
20
Repeat this for each channel and or zone. Then, on the zones you want to
access one of the BUS sources, put the input switch into the appropriate
setting A or B position. Proceed to connect the speaker cable to the amplifier
as per the instruction the "Stereo Connection" section of this manual.
IV. GENERAL MAINTENANCE AND SERVICE
The front panel is finished with a high-grade anodizing process to ensure that
it maintains a flawless appearance. Occasionally, you should wipe off any
dust build up with a damp, soft cloth.
DO NOT USE ANY KIND OF CLEANING SOLUTION OR CLEANSER ON THESE UNITS.
IF FOR SOME REASON THE AMPLIFIER NEEDS TO BE REPAIRED, PLEASE CONTACT
US IMMEDIATELY. WE WILL ISSUE A RETURN AUTHORIZATION NUMBER. THIS UNIT
SHOULD NOT BE SHIPPED BACK TO ELIPSON WITHOUT THE RA#.
DO NOT ATTEMPT TO OPEN OR DISMANTLE THIS AMPLIFIER.
THIS WILL VOID THE WARRANTY !
21
Publicité
