Bombard SUNRIDER 700 Manuel Du Propriétaire page 55

BUOYANCY CHAMBER – FIXING THE PROTECTIVE FLAP
II -3-SECURING THE PROTECTIVE FLAP
4
Fit the internal waterproofing guard.
5 6
Fix the waterproofing flap to the hull using screws and fabric washers (supplied), raising the
buoyancy chamber's nose.
7
Bring forward the buoyancy chamber's nose in order to pull the exterior protective flap under the
hull's nose.
Pull the 2 tabs on the buoyancy chamber again as far as possible to the aft of the boat, and centre
the nose with the bow of the hull.
Slightly inflate the nose of the buoyancy chamber to make sure that it is properly centred and
perfectly fits hull.
Repeat the operation if the buoyancy chamber is not properly positioned.
Page 10 / 43