Venga VG RVC 3002 Mode D'emploi page 18

CLEANING AND MAINTENANCE
In order to ensure maximum suction power of the robot and long-term reliability, we
recommend that you follow the following care tips regularly.
Note: Disconnect the robot from power supply and allow it to cool before cleaning.
Never submerge the robot, the charging station or the power adaptor in water or any
other liquid or place it under running water. To avoid damaging the internal parts of the
device, do not allow water or other liquids to enter the ventilation slots.
Recommended frequency of cleaning / replacement of spare parts:
Dust collector
Filters
Central brush
Side brushes
Sensors
Charging pins
Swivel wheel
A. Emptying and cleaning the dust collector
1. Press the release button to remove
the dust collector.
3. Remove the primary filter by grasping
the yellow tab and take out the HEPA
filter from it.
VG RVC 3002
Cleaning
After each use
Once every week
Once every week
Once every month
Once every month
Once every month
Once every month
Replacing
-
Every 2 months
Every 6-12 months
Every 3-6 months (or when visibly
worn)
-
-
-
2. Open dust collector's hatch to
empty it.
4. Shake off debris and dust from the
filters.
18