Venga VG RVC 3002 Mode D'emploi page 14

REMOTE CONTROL
Note: Install 2 AAA batteries before using the remote control for the
first time. Make sure the positive and negative ends are facing the
correct direction as indicated in the battery compartment
START / STOP button
Wake up the robot vacuum cleaner and start / pause / continue
the cleaning cycle.
Return to charging station button
To stop the cleaning and the cycle and the robot
to send back to the charging station.
Guidance buttons:
If you want to guide the robot to a specific spot, press the direction button
▲/▼to move forward/backward and ◄/► to rotate left/right.
CLEANING MODES
Auto Cleaning Mode: the robot starts cleaning and combines the
different cleaning modes in one mode to optimize the cleaning of
your house to the maximum. The robot continues this process until
it has cleaned the entire area. When the cleaning cycle is finished,
the robot returns to the charging station to recharge.
Press the button on the remote control to start the program.
Spot Cleaning Mode: The robot will use a designated point as the
center of the area to focus, and will clean with horizontal and
vertical paths.
To start, place your robot on top of the spot to clean and press
on the remote control.
Edge Cleaning Mode: in Auto Cleaning mode, the robot starts the
edge cleaning mode automatically once it has finished cleaning
the open areas to ensure cleaning along the walls.
Press the button on the remote control to start this mode.
Maximum Suction: The robot increases its suction power to allow a
more thorough cleaning.
Note: Maximum suction can only be activated during operation in Auto
cleaning mode.
VG RVC 3002 14