VEHNS GROUP XZ YEAZ Mode D'emploi page 14

and turn it clockwise to lock it in the "open" position. When deflating, make sure there is no sand
or dirt around the valve or inside.
CAUTION: Remove the valve cover only to inflate/deflate air. This will prevent accidental escape
of air and ingress of any particles into the valve.
MOUNTING THE FIN
ATTENTION: The fin can be mounted on the inflated and not inflated board. The curvature of the
fin must point in the same direction as the fixed smaller fins. Depending on the model there are
different fixations for the fin.
Removable fixation on the fin (metal plate and screw):
Insert the metal plate into the rail, insert the fin and fix it in the ideal position using the screw.
The screw is turned into the hole of the metal plate.
Fixing part for the fin fixed with cord:
Insert the fin into the splint. Slide the plastic part attached to the string underneath the fin until it
snaps into the recess provided.
If you expose your item to the hot sun, please check the air pressure and release a little air,
otherwise the material may be overstretched. The ambient temperature affects the internal
pressure of the chambers: a deviation of 1°C results in a pressure deviation in the chamber of +/-
4 mBar (0.06 PSI). Please note: The valve is only airtight when closed with the valve cap. The use
of a compressor can damage your article, all warranty claims expire when using a compressor.
1. AIR DEFLATION - 2. FOLDING - 3. CLEANING - 4. STORAGE
1. Deflate the air and remove the fin.
14