Publicité
Les langues disponibles
Les langues disponibles
EN
before attempting to jump start the vehicle again.
5.) Once you have started your vehicle, power off the unit, disconnect the battery clamps, and remove the GB500.
60-Second Timeout.
A 60-Second Countdown will be initiated as soon as a battery is detected. After 60 seconds has elapsed, the jump starting function will
be disabled. The boost LED will turn off and the internal battery charge LEDs will indicate the current charge level of the unit. To reset the
jump-starting function, press the power button to power off the unit. Press the power button again to power on the unit and restart the
jump starting function.
CAUTION.
60-SECOND TIMEOUT IS DISABLED WHILE USING MANUAL OVERRIDE MODE. POWER WILL CONTINUE TO BE SUPPLIED WHILE
MANUAL OVERRIDE IS ACTIVE. TO MAXIMIZE THE NUMBER OF JUMP-STARTS, IT IS RECOMMENDED TO TURN OFF THE BOOST-
UNIT AS SOON AS THE VEHICLE HAS STARTED.
Low Voltage Batteries & Manual Override.
The GB500 is designed to jump start batteries down to 3-volts. If your battery is below 3-volts, the Boost LED will be "Off". This is an
indication that the GB500 can not detect a battery. If you need to jump start a battery below 3-volts there is a Manual Override feature,
which allows you to force "On" the jump start function.
CAUTION.
USE THIS MODE WITH EXTREME CARE. THIS MODE IS FOR 12-VOLT OR 24-VOLT LEAD-ACID BATTERIES ONLY. ENSURE THE
VOLTAGE SELECTION KNOB IS IN THE CORRECT POSITION (12V OR 24V) MATCHING THE BATTERY SYSTEM BEING JUMP
STARTED. BOTH THE SPARK PROOF AND REVERSE POLARITY PROTECTION FEATURES ARE DISABLED. PAY VERY CLOSE
ATTENTION TO THE POLARITY OF THE BATTERY BEFORE USING THIS MODE. DO NOT ALLOW THE POSITIVE AND NEGATIVE
BATTERY CLAMPS TO TOUCH OR CONNECT TO EACH OTHER AS THE PRODUCT WILL GENERATE SPARKS. THIS MODE USES
VERY HIGH CURRENT (UP TO 6250AMPS) THAT CAN CAUSE SPARKS AND HIGH HEAT IF NOT USED PROPERLY. IF YOU ARE
UNSURE ABOUT USING THIS MODE, DO NOT ATTEMPT AND SEEK PROFESSIONAL HELP.
Publicité
