Publicité
Les langues disponibles
Les langues disponibles
9. Continued.......
Programming the 2nd user code.
a. Press the program button on the interior unit twice.
b. Enter in 4 to 8 digit code onto the keypad.
c. Press the "LOCK" button to save code.
Extend the bolt by pressing the "LOCK" button and re-enter the code
d.
to test. The bolt should retract to the unlocked position. If it does not
unlock, repeat steps (a) through (c).
Note: Programming instructions can also be found on interior of lock.
CAUTION: Prevent unauthorized entry. This lock can be opened
using two different codes that are randomly set at the factory. Upon in-
stallation and set-up, replace both of these codes with your own. Since
anyone with access to the power board can change these codes, you
must restrict access to the power board and routinely check both codes
to assure they have not been altered without your knowledge.
10. SmartCode User Selectable Settings.
Switch #1
5 seconds when in the ON position. Note:
The low battery RED LED cannot be
disabled.
Switch
Position
ON
OFF
Switch #2
in the ON position. With Auto Lock enabled,
SmartCode will automatically relock the door
(extend the bolt) 30 seconds after unlocking.
Switch #3
position. Keypad will now light red/green when buttons are pressed.
Switch #4
Hint: for easier access, use a ball point pen to operate the switches.
Status LED blinks every
LED
Color
Green
Orange
Red
Red
Enables the AUTO LOCK when
Enables the AUDIO sound (Beeper) when in the ON
Extra switch with NO FUNCTION.
Lock
Status
Unlocked
Locked
Low Battery
Low Battery
O N
1
2
3
4
Switches
LED
7
Publicité
