Smart Code Aegis 7000 Guide De Référence Rapide page 5

7. Install batteries into battery pack.
Note: Do not install battery pack into unit until you start step 8.
a. Install 4 new AA Alkaline batteries.
Install the new batteries as indicated in illustration. Make sure
batteries lie flat in holder. For best performance,
rechargeable batteries are not recommended.
Alkaline Battery WARNING:
put in backwards, disassemble, mix with used or other battery types. May
explode or leak and cause personal injury.
IMPORTANT: DO NOT SKIP THE FOLLOWING STEP.
LOCK WILL NOT BE ABLE TO OPERATE PROPERLY!
8. Automatic - Bolt Direction Determination (Door Handing).
● In the steps below, the SmartCode mechanism automatically
determines the "door handing" and sets the proper direction for mo-
tor to rotate. The system will drive the bolt several times during this
process.
a. Press and hold the "LOCK" button on the exterior keypad, while fully
inserting the battery pack into the interior assembly (the tab on the pack
must face out - see illustration). Hold down lock button until you hear 2
beeps (about 20 seconds). It is very important that this process is
allowed to finish properly.
LOCK
Button
Tab
1
O R
R I
T E
E X
Do not dispose of in fire, recharge,
Battery Pack
LED
2
2
I N
T E
R I
O R
Continued
1
5