Information And Settings; Displaying Information; Displaying Settings - NEFF CV 7760 N Mode D'emploi

Information and settings

Use i (1) to display information (press briefly)
and adjust settings (hold down for at least
three seconds).

Displaying information

In the Info menu (press i briefly) you can call
up the following information:
when it is necessary to descale the
X
appliance
when it is necessary to clean the
X
appliance
when it is necessary to change the filter
X
how much coffee has been dispensed
X
since the appliance was first put into
operation
how many milk drinks have been
X
dispensed
how much hot water has been prepared
X

Displaying settings

Hold down i (1) for at least 3 seconds; the
different setting options are then displayed:
Settings
Language
English
Y Z
Use (2) and (5) to switch between the
different setting options. The currently active
setting is always shown in a larger font. You
can change the setting that is currently dis-
played using the navigation button
To exit the menu, press i (1) again.
The changes you have made are
saved automatically. It is not neces-
sary to confirm them additionally.
Neff
The following setting options are
available to you:
Language
to select the display language.
Cup volume
set separately for each type of drink and
each cup size (see "Set per-cup quantity").
Water hardness
ton
ness (1, 2, 3 or 4) (refer also to "Checking
and setting the water hardness").
Coffee temperature
button
Auto off after
appliance should automatically switch off
following the last drink preparation. A time
between 5 minutes and 8 hours can be set.
The default time is 30 minutes, but this can
be shortened to save energy.
Contrast
from – 4 to + 4 with the navigation button
Illumination
On
Water filter
is inserted in the water tank (8), it must be
rinsed:
1. Place the water filter in the water tank
Cup volume
2. Use the navigation button
3. Place a container with a capacity of
4. Press
(4).
Empty the container. The appliance is ready
to use once more.
Rinsing the filter simultaneously activates
the setting for the
display.
: Press the navigation button
: The per-cup quantity can be
: Press the navigation but-
(4) to select the required water hard-
(4) to set the coffee temperature.
: Press the navigation button
(4) to enter the time span after which the
: The display contrast can be set
(4). The default setting is 0.
: The lighting can be set to
(factory setting) or
: Each time a new water filter
(8) and fill the tank with water up to the
"max" mark.
Y
Press and press
0.5 litres under the milk frother (19).
z
(6). Water will now run first
through the filter to rinse it and then into
the container.
Service - change filter
English | 47
: Press the navigation
Off
.
Off after 5 min
(4) to select
z
(6).
C77V60N2 | 02/2012
(4)
,