Preparing Milk Froth And Warm Milk; Dispensing Hot Water - NEFF CV 7760 N Mode D'emploi

46 | English
The changes you have made are
saved automatically. It is not neces-
sary to confirm them additionally.
Preparing milk froth and warm
milk
Risk of burns!
The milk frother (19) gets very
hot. After use, allow to cool down
first before touching.
For optimal milk froth, use cold milk
with a fat content of at least 1.5 % if
possible.
1. Take the milk tube (12) and connect it to
the milk frother (19)
(see "Preparation using milk").
2. Place a cup or glass under the outlet of
the milk frother.
3. Select the required setting for
or
Warm milk
(4):
My coffee
z
4. Press (6).
Milk froth or warm milk runs out of the milk
frother outlet (takes about 40 or 60 seconds
respectively).
z
Press (6) again to cut the process short.
The appliance may make a whistling
noise when warm milk is being
prepared. This is caused by the milk
frother (19) for technical reasons.
Dried milk residue is difficult to
remove, so clean the milk frother
immediately after use (see
" Cleaning the milk system").
Neff
Milk froth
with the navigation button
Milk froth
Warm milk

Dispensing hot water

Risk of burns!
The milk frother (19), from which
the hot water flows, gets very hot.
After use, allow to cool down first before
touching.
The appliance can also be used to dispense
hot water, e.g. for tea.
1. Place a cup or glass under the coffee
outlet.
2. Select
Hot water
button (4):
Warm milk
Z
3. Press (5) to switch to the temperature
selection. Set the required temperature
with the navigation button
∼ 80ºC
z
4. Press (6).
Hot water runs out of the milk frother outlet
for about 40 seconds.
z
Press (6) again to cut the process short.
Warm up cups before use,
especially small, thick espresso
cups, with the hot water.
with the navigation
Hot water
Short rinse
∼ 85ºC
(4):
Hot water
∼ 85ºC
∼ 90ºC
C77V60N2 | 02/2012