VSG 000 Serie Instructions D'installation page 20

14. Anchoring
1. Turn the disconnect switch to "ON" and press the
"UP" button to raise the platforms which provides
room under the runways for drilling.
2. Drill and install (8) eight lift anchors loosely. Do not
tighten.
3. Complete leveling measurements described under
item number 13.
4. Shim as necessary, Fig. 10, and tighten anchors.
5. Grout if necessary (see section 15).
6. Re-check for levelness.
WARNING
Do not install this lift without anchoring
to required specifications. Failure could result in
personal injury or death.
20
Fig. 9c
Fig. 9d
Fig. 10