Publicité
Les langues disponibles
Les langues disponibles
PREPARE THE HOOD
Unpack hood and check contents.
You should receive:
1 - Hood
1 - Parts Bag (B080810168) containing:
4 - Mounting Screws (3,2 x 13mm)
1 - Installation Instructions
EXTERIOR BLOWER SELECTION
This product is designed for use with the EB6, EB9, EB12 or EB15 Exterior
Ventilators.
The exterior ventilator must be UL listed for Canadian and U.S. use, and evaluated
for use with solid state speed control rated 120V, 60 Hz, 6.0 A max.
INSTALL THE DUCTWORK
NOTE: To reduce the risk of fire, use only
metal ductwork.
1. Decide where the ductwork will run
between the hood and the outside.
2. A straight, short duct run will allow the hood
to perform most efficiently.
3. Long duct runs, elbows, and transitions will
reduce the performance of the hood. Use
as few of them as possible. Larger ducting
may be required for best performance with
longer duct runs.
4. Install a exterior blower. Connect round
metal ductwork to exterior blower and work
back towards hood location. Use duct tape
to seal the joints between ductwork
sections.
5. An 8" to 10" transition (Model 414) will be
necessary to connect to the exterior
ventilator.
It is reccommended that the transition be
installed as near to the hood as possible.
4 MOUNTING
SCREWS
EXTERIOR
BLOWER
8" ROUND
DUCT
HOOD
24" TO 30" ABOVE
COOKING SURFACE
- 4 -
(3,2 x 13mm)
10" ROUND
8" TO 10"
DUCT
ROUND
ADAPTER
EXTERIOR
BLOWER
10"
ROUND
DUCT
8" ROUND
ELBOW
Publicité
