Publicité
558Wa Westport Storage Shelf
Phillips Head Screwdriver, Rubber Mallet or Padded Hammer, Wood Glue, Tape Measure
We recommend that you apply the finish before you assemble this unit.
F
1. Place the Bottom Shelf (F) on a clean, protected surface so the pocket holes face up. Spread a thin
layer of glue in the dowel holes on the Bottom Shelf and insert the Left Vertical Divider (E) and Right
Vertical Divider (D) so that the square notches face the back as shown in Figure 1. Tap with a rubber
mallet and quickly wipe away any excess glue with a damp rag. Using the pocket holes as guides,
attach with four #8x1-3/16" Pan Head Screws (T). See Figure 1.
2. Spread a thin layer of glue in the upper two dowel holes on the Left Side (C) and insert the Bottom
Shelf Assembly. Tap with a rubber mallet and quickly wipe away any excess glue. Using the pocket
holes as guides, attach the Left Side (C) to the Bottom Shelf Assembly with two #8x1-3/16" Pan Head
Screws (T), making sure the square notches on the Left and Right Dividers face the back and the
curved notch on the Left Side faces the front. See Figure 2.
Assembly Instructions
Tools Required:
Important Notes:
Before doing so, completely read the enclosed Finishing Hints.
E
T
Fig. 1
C
T
Fig. 2
D
T
View from the Front
T
x 4
T
x 2
558Wa — 03/10 — Page 3
Publicité
