EXALTA TRECENTO12 Manuel D'instruction page 15

With charging support
Make sure the appliance is switched off.
- Place the hair clipper on the charging support.
- Connect the appliance plug with charging support and the power plug
with the socket.
- As soon as you start charging the hair clipper, the LED lights up.
- For the first use it is necessary to charge the appliance for 24 hours
continuously.
- Future charges need approximately 6 hours, and then it is possible to
disconnect the appliance from the socket.
Without charging support
It is possible to charge the appliance connecting it directly with socket.
A complete charge provides a cutting time up to 30/45 minutes.
It is advisable to charge battery when it is totally discharged and not to
charge the appliance more than 48 hours; it will ensure a longer life to
your product.
Once the charge has ended, disconnect the appliance from the socket.
After every usage, you can store the appliance on its support.
The charging light does not go out or change colour when the appliance
is fully charged.
To use the hair clipper connected to the mains: switch the hair clipper off,
connect it to the mains and wait a few seconds before switching it on.
ON /OFF
Please use the ON/OFF button both for turning on and off the appliance.
CUTTING LENGHT ADJUSTMENT
The Hair Clipper is provided with 2 cutting guides, necessary to adjust the
cutting length from 1mm (without cutting guide) to 12 mm (with cutting
guide).
The cutting lengths are the following:
Without cutting guide: 1mm
Cutting guide 3 or 6 mm. It depends on the attached guide side.
Cutting guide 9 or 12 mm. It depends on the attached guide side.
WARNING: when you fit or remove the cutting guide, the appliance
15