Publicité
Les langues disponibles
Les langues disponibles
Engine Frame and
Wheel Assembly
High Pressure
Hose
1.
Place handle assembly onto frame,
depress the snap buttons, and
slide the handle assembly onto the
frame until snap buttons snap into
place.
2.
Attach high
pressure hose
to gun. Tighten
securely.
3.
Connect wand to gun. Tighten
securely.
4.
Place the nozzle holder onto
the panel (located on the handle
assembly) and push each nozzle
holder into place.
A13548
CARTON CONTENTS
English/
Spanish
Operation
Chemical
Manual
Hose
Engine
Registration
Manual
Spray Gun
Quick Connect Spray Wand
ASSEMBLY INSTRUCTIONS
Nozzle
Cleaning
Tool
card
Bagged Parts
5.
Remove five colored quick
connect nozzles from plastic
bag and insert them into correct
grommet on the nozzle holder.
NOTE: Nozzles are color coded
to match colored nozzles on
panel.
NOTE: The high pressure pump was
filled with oil at the factory. There is no
need to add oil at this time, see the
Maintenance section of this manual
for Maintenance information.
and replaced with the dipstick/oil
plug before operating pressure
washer.
6.
Using a 7/8" wrench,
remove shipping plug
from pump by turning
it counterclockwise.
Discard plug.
7
Remove dipstick/oil plug from
plastic bag and install into pump,
tighten securely.
6- ENG
Nozzle
Holder
Quick
Connect
Nozzles
Handle
The shipping plug
must be removed
Publicité
